M847D1004 Damper Actuator Motor (2 Wire), Compatible with Honeywell M847D Series Motors ZD and ARD dampers, HVAC Zone General Purpose Spring Return Dampener Actuator Motor, 24 VAC 60Hz, #M847D1012 | Repair and Installation Guide

Packing List:

1 x 2-wire Spring Return Damper Actuator Motor

Condition: New

Compatible with:

Honeywell M847D series motors, on popular old ARD and ZD series of dampers, including M847D1004, M847D1012.

(NOT work with Honeywell ZD Rectangular Dampers)

DuroZone #35105 damper Motor & similar HVAC spring-return 2-wire damper actuators by Zone First, Erie, and others.

Specifications:

Voltage: 24vac ± 10%, 60 Hz, 0.36A

Torque Rating: Power open 32 in. oz./spring close 32 in. oz. – torque is consistently delivered throughout the full 90° rotational operating range to open and close the damper, irrespective of whether the actuator is operating in Power Advance Mode (energized) or Spring Return Mode (de-energized)

Speed Stroke: Motor driven 30 sec./spring return 6 sec.

Rotating Angle: 93.5°

Noise Level: Very quiet operation, typically ≦ 40dB at 3′

Reliability: Statistical life reliability exceeds 120,000 cycles at 90% reliability and 100% confidence with no decay in delivery torque over the life of the actuator

Installation:

Step 1: Disconnect the power supply before connecting the motor wiring to prevent electrical shock or equipment damage.

Step 2: Using a hex wrench, loosen the motor coupling from the blade shaft and remove the existing motor assembly.

Step 3: Ensure that the damper blades are in the correct installation position.

Step 4: Loosen the set screw on the motor collar.

Step 5: Place the actuator onto the damper shaft and insert the anti-rotation pin into the anti-rotation pin hole.

Step 6: Double check that your damper blade and shaft are in the correct installation position for your application, then lock the collar onto the damper shaft by tightening the set screw on the collar.

Step 7: Reconnect the motor wiring.

About this item

• 【Specialized Design】24vac spring return damper actuator is designed to operate directly driven zone dampers, used to control airflow in ducts. The synchronous motor actuator can be driven open (or close) using any 24-volt rated two-position switch.
• 【Easy to Install】The damper actuator motor is manufactured to the OE specification to provide factory appearance and direct-fit, just takes 10 minutes to replace the old one.
• 【Premium Material】Long life-span matters, that’s why our zone damper motor is made from durable stainless steel material, which has good oxidation stability, rust and corrosion resistance. Meanwhile, anti-high and low temperatures, waterproof, even in a rough environment, can work very well easily.
• 【Fit for】Our 2 wire spring return damper motors are designed as drop-in replacements for Honeywell’s M847D series motors on popular old ARD and ZD series of dampers, including M847D1004, M847D1012, and many other damper actuators that use the same footprint.
• 【24-Month Warranty】If for any reason at all, you are not satisfied with this honeywell damper actuator motor, you can contact us through imaginebroward.org message to apply the service of carefree REPLACEMENT or REFUND.